Franklin County · Free Estimate
Paver Installation in Bexley, OH
Paver patios, driveways, walks, steps and walls in Bexley, laid on a compacted base. Ask for a free estimate.
Paver work in Columbus and 31 towns, inside I-270 and beyond
Paver Install Estimate: Bexley
Tell us the kind of paver job, a rough size and anything you have noticed about drainage or sinking. The contractor will call you back and arrange a time to see it.
- Free estimates
- Base built in lifts
- Repairs and releveling
- Patios to retaining walls
Rough sizes are fine. We measure on site. 👇
Bexley, Ohio
How we build paver jobs in Bexley
Roughly 3 miles east of downtown Columbus, Bexley gets the same method from us: plate-compacted base, screed rails, clean wet-saw cuts and polymeric joints. What changes from yard to yard is the soil, the slope and where the water goes, and we read each one before digging.
Polymeric sand needs a dry forecast to set, so in a wet Columbus spring the joint sand sometimes waits a day or two after the pavers are laid. A plate compactor works Central Ohio clay best when the soil is damp but not wet, since dry clay is hard to dig and wet clay pumps up into the base.
Planning a patio, walk, driveway or wall in Bexley? Fill in the form or call, and we will book a visit to look at the ground and price the job for free.
What we install
Services for Bexley
Paver Patios
Paver patios built on compacted limestone bases in Bexley.
More on paver patios
Paver Driveways
Paver driveways built on deep, compacted bases in Bexley.
More on paver driveways
Paver Walkways
Paver walkways and side paths with cut-in-place curves in Bexley.
More on paver walkways
Paver Steps
Paver steps for entries, patios and slopes in Bexley.
More on paver steps
Block Walls
Segmental block retaining walls with drainage behind them in Bexley.
More on block walls
Paver Repair & Releveling
Paver repair, releveling and joint sand work in Bexley.
More on paver repair & releveling
Franklin County, Ohio
Around Bexley
Paver jobs in Bexley, whether they sit by Jeffery Park, Nelson Park and Capital University Historic District or across town, start under the surface. We dig past the topsoil, compact stone in lifts and only then lay the pavers.
Retaining walls on Central Ohio slopes fail from water pressure far more often than from weight, which is why drainage stone and a pipe behind the block matter so much.
Close to Bexley, paver installation and releveling are also available in Whitehall, Columbus, Blacklick Estates and Grandview Heights, with the same base work and finish.
Examples
Paver jobs from base stone to finished joint
Example photos of the type of work.
Questions
Bexley questions
How deep do you dig for pavers in Bexley?
It depends on what the pavers will carry. A walk needs the least base, a patio more and a driveway the most, and soft or wet clay adds to any of them, so the depth is set after looking at the soil.
Can you relevel sunken pavers in Bexley?
Yes. We lift the pavers in the low area, rebuild and compact the base, screed fresh sand and relay the same pavers. The joints then get new polymeric sand.
Do I need a permit for paver work in Bexley?
It depends on the project and the local rules. Patios and walks on your own lot are often simple, while driveway aprons at the street and taller retaining walls more often need a permit or a design, and we check what applies before work starts.
Do you install pavers in Bexley year-round?
Most of the year, yes. Frozen ground cannot be dug or compacted, and soaked clay has to dry out before it will take a base, so a cold snap or a wet week can push back the start date.
How do I get a paver estimate in Bexley?
Call (614) 810-4672 or fill out the form with the size and type of paver job. We will call back, arrange a visit to see the site and give you a free estimate.
What has to happen before you dig?
An 811 call to OUPS, made at least two working days ahead, so utility lines are marked. Driveway aprons in the right-of-way and taller retaining walls can need a permit from the city or township, and some walls need an engineer's design. If you have an HOA, get materials and colors cleared with them first.
Start with a walk-through and a free estimate
Send a few details or call, and we will come measure, check the grade and price the job.